Support

NX-P1202AV/P1302AU

Specifications

General NX-P1202AV NX-P1302AU
Pre-set Frequencies 151-159 MHz 451-470 MHz
Max. Channels per Radio 64 channels
Number of Zones 4 zones
Max. Channels per Zone 16 channels
Channel Spacing Analog 25*1 / 12.5 kHz
Power Supply 7.5 VDC ±20 %
Battery Life (5-5-90) KNB-45L (2000mAh) Approx. 15 hours
KNB-69L (2550mAh) Approx. 19.5 hours
Operating Temperature(Radio only)*2 -22°F to +140°F (-30°C to +60°C)
Frequency Stability (-30 to +60°C; +25°C Ref.) ±0.5 ppm
Antenna Impedance 50 Ω
Dimensions (W x H x D) Projections Not Included
Radio with KNB-45L/82LCM 2.13 x 4.84 x 1.32 in (54 x 123 x 33.5 mm)
Radio with KNB-69L 2.13 x 4.84 x 1.48 in (54 x 123 x 37.5 mm)
Weight Radio Only 5.64 oz (160 g)
Radio with KNB-45L/82LCM 9.88 oz (280 g)
Radio with KNB-69L 10.41 oz (295 g)
FCC ID K44501000 K44501101

*1 25 / 30 kHz in VHF/UHF Bands excluding T-Band are not included in the models sold in the USA or US territories.
*2 Operating temperature specification for a Li-ion battery is -10°C to +60°C [14°F to +140°F].
Specifications shown are typical and subject to change without notice, due to advancements in technology
Details and timing of firmware and software updates are subject to change without notice.
Analog measurements made per TIA603. Specifications are measured according to applicable standards.
All interfaces must be fully sealed with appropriate covers or by designated genuine accessories.



Receiver NX-P1202AV NX-P1302AU
Sensitivity Analog @ 12.5/25 kHz (12 dB SINAD) 0.20 μV / 0.24 μV
Selectivity Analog @ 12.5 / 25 kHz 68 dB / 74 dB
Intermodulation Distortion 70 dB
Spurious Rejection 70 dB
Audio Distortion 7%
Audio Output Power 1 W / 12 Ω (Internal Output)
500 mW / 8 Ω (External Output)


Transmitter NX-P1202AV NX-P1302AU
RF Power Output*2 (High / Low) 2 W / 1 W
Spurious Emission -70 dB
FM Hum & Noise Analog @ 12.5 / 25 kHz 40 dB / 45 dB
Audio Distortion 2%
Emission Designator 16K0F3E,*1 11K0F3E, 8K30F1E, 8K30F1D,
8K30F7W, 4K00F1E, 4K00F1D, 4K00F7W, 4K00F2D

FleetSync® is a registered trademark of JVCKENWOOD Corporation in the United States and/or other countries.
NEXEDGE® is a registered trademark of JVCKENWOOD Corporation.
ProTalk® is a registered trademark of JVCKENWOOD Corporation.
All other trademarks are the property of their respective holders.



MIL-STD & IP

MIL Standard MIL 810C Methods/Procedures MIL 810D Methods/Procedures MIL 810E Methods/Procedures MIL 810F Methods/Procedures MIL 810G Methods/Procedures
Low Pressure 500.1/Procedure I 500.2/Procedure I, II 500.3/Procedure I, II 500.4/Procedure I, II 500.5/Procedure I, II
High Temperature 501.1/Procedure I, II 501.2/Procedure I, II 501.3/Procedure I, II 501.4/Procedure I, II 501.5/Procedure I, II
Low Temperature 502.1/Procedure I 502.2/Procedure I, II 502.3/Procedure I, II 502.4/Procedure I, II 502.5/Procedure I, II
Temperature Shock 503.1/Procedure I 503.2/Procedure I 503.3/Procedure I 503.4/Procedure I, II 503.5/Procedure I
Solar Radiation 505.1/Procedure I 505.2/Procedure I 505.3/Procedure I 505.4/Procedure I 505.5/Procedure I
Rain* 506.1/Procedure I, II 506.2/Procedure I, II 506.3/Procedure I, II 506.4/Procedure I, III 506.5/Procedure I, III
Humidity 507.1/Procedure I, II 507.2/Procedure II, III 507.3/Procedure II, III 507 507.5/Prcedure II
Salt Fog 509.1/Procedure I 509.2/Procedure I 509.3/Procedure I 509 509.5
Dust 510.1/Procedure I 510.2/Procedure I 510.3/Procedure I 510.4/Procedure I, III 510.5/Procedure I
Vibration 514.2/Procedure VIII, X 514.3/Procedure I 514.4/Procedure I 514.5/Procedure I 514.6/Procedure I
Shock 516.2/Procedure I, II, V 516.3/Procedure I, IV 516.4/Procedure I, IV 516.5/Procedure I, IV 516.6/Procedure I, IV
International Protection Standard
Dust & Water Protection* IP54/55* *To meet IP54/55, the 2-pin connector cover has to be connected on the radio or the locking bracket has to be attached to the external speaker microphone.