| GENERAL | ||
|---|---|---|
| Frequency Range | Type 6 | 350 - 390 MHz |
| Number of Channels | Max.16 | |
| Channel Spacing | Wide/Narrow | 25 kHz / 12.5 kHz |
| Battery Voltage | 7.5 V DC ±20 % | |
| Battery Life (5-5-90 duty cycle, during hi-power battery saver: OFF/ON) | with KNB-45L (2000 mAh) | Approx. 12 hours / 18 hours |
| with KNB-29N (1500 mAh) | Approx. 10 hours / 14 hours | |
| with KNB-30A (1100 mAh) | Approx. 9 hours / 11 hours | |
| Operating Temperature Range* | -30°C ~ +60°C | |
| Frequency Stability | ±2.5 ppm (-30°C ~ +60°C) | |
| Antenna Impedance | 50 Ω | |
| Dimensions (W x H x D), Projections not Included | with KNB-45L / 29N / 30A | 54 x 122 x 33.8 mm |
| Weight (net) | Radio only | 160 g |
| with KNB-45L | 280 g | |
| with KNB-29N | 360 g | |
| with KNB-30A | 340 g | |
| RECEIVER | ||
| Sensitivity | EIA 12 dB SINAD Wide / Narrow | 0.25 µV / 0.28 µV |
| Adjacent Channel Selectivity | Wide / Narrow | 70 dB / 60 dB |
| Intermodulation | Wide / Narrow | 65 dB / 60 dB |
| Spurious Response Rejection | 60 dB | |
| Audio Output (4 Ω impedance) | 500 mW with less than 10 % distortion | |
| Measurement | TIA / EIA-603 | |
| TRANSMITTER | ||
| RF Power Output (High/Low) | 4 W / 1 W | |
| Modulation Limiting | ±5.0 kHz at 25 kHz ±2.5 kHz at 12.5 kHz |
|
| Spurious Emission | 65 dB | |
| Modulation | Wide / Narrow | 16K0F3E / 11K0F3E |
| FM Noise (EIA) | Wide / Narrow | 45 dB / 40 dB |
| Modulation Distortion | Less than 5 % | |
| Microphone Impedance | 2 kΩ | |
| Measurement | TIA / EIA-603 | |
* -10°C ~ +60°C when KNB-29N or KNB-45L in use.
KENWOOD follows a policy of countinuous advancement in development.
For this reason specifications may be changed without notice.
FleetSync™ is a registered trademark of KENWOOD Corporation.
Windows© is a registered trademark of Microsoft Corporation in the United States and other countries.
| Standard | MIL 810C Methods/Procedures | MIL 810D Methods/Procedures | MIL 810E Methods/Procedures | MIL 810F Methods/Procedures |
|---|---|---|---|---|
| Low Pressure | 500.1/Procedure I | 500.2/Procedure I | 500.3/Procedure I | 500.4/Procedure I, II |
| High Temperature | 501.1/Procedure I, II | 501.2/Procedure I, II | 501.3 | 501.4/Procedure I, II |
| Low Temperature | 502.1/Procedure I | 502.2/Procedure I, II | 502.3/Procedure I, II | 502.4/Procedure I, II |
| Temperature Shock | 503.1/Procedure I | 503.2/Procedure I | 503.3/Procedure I | 503.4/Procedure I, II |
| Solar Radiation | 505.1/Procedure I | 505.2/Procedure I | 505.3/Procedure I | 505.4/Procedure I, II |
| Rain | 506.1/Procedure I, II | 506.2/Procedure I, II | 506.3/Procedure I, II | 506.4/Procedure I, III |
| Humidity | 507.1/Procedure II | 507.2/Procedure II | 507.3/Procedure II | 507.4 |
| Salt Fog | 509.1/Procedure I | 509.2/Procedure I | 509.3/Procedure I | 509.4 |
| Dust | 510.1/Procedure I | 510.2/Procedure I | 510.3/Procedure I | 510.4/Procedure I, III |
| Vibration | 514.2/Procedure VIII, X | 514.3/Procedure I Cat. 8 | 514.4/Procedure I Cat. 8 | 514.5/Procedure I Cat. 20 |
| Shock | 516.2/Procedure I, II, V | 516.3/Procedure I, IV | 516.4/Procedure I, IV | 516.5/Procedure I, IV |
| International Protection Standard | ||||
| Dust & Water Protection* | IP54/55 | |||
*To meet IP54/55, the 2-pin connector cover has to be connected on the radio; the locking bracket has to be attached to the KMC-45 external speaker microphone.
