| TK-2307 | |
|---|---|
| GENERAL | |
| Frequency Range Type M Type M2 Type C2 Type C6 Type 1 |
136 ~ 174 MHz |
| Number of Channels | Max.16 |
| Channel spacing Wide / Narrow |
25 kHz / 12.5 kHz |
| Battery Voltage | 7.5 V DC ± 20% |
| Battery Life (5-5-90 duty cycle, saver OFF/ON) with KNB-45L (2000 mAh) with KNB-29N (1500 mAh) with KNB-30A (1100 mAh) | Approx. 12 hours / 18 hours Approx. 10 hours / 14 hours Approx. 9 hours / 11 hours |
| Operating Temperature Range | -30°C to +60°C (-10°C ~ +60°C when KNB-55L / 57L in use) |
| Frequency Stability | -30°C ~ +60°C |
| Antenna impedance | 50 Ω |
| Dimensions (W x H x D), Projections not included with KNB-45L/29N/30A |
54 x 122 x 33.8 mm |
| Weight (net) Radio Only with KNB-45L with KNB-29N with KNB-30A | 160 g 280 g 360 g 340 g |
| RECEIVER | |
| Sensitivity (12 dB SINAD) Wide / Narrow |
0.25 µV / 0.28 µV |
| Adjacent Channnel Selectivity Wide / Narrow |
70 dB / 60 dB |
| Intermodulation Wide / Narrow |
65 dB / 60 dB |
| Spurious Response | 75 dB |
| Audio Output(8Ω impedance) | 500 mW with less than 10% distortion |
| TRANSMITTER | |
| RF Power Output High / Low | 5 W / 1 W |
| Modulation Limiting | ±5.0 kHz at 25 kHz ±2.5 kHz at 12.5 kHz |
| Spurious Response | 65 dB |
| Modulation Wide / Narrow |
16K0F3E / 11K0F3E |
| FM Noise(EIA) Wide / Narrow |
45 dB / 40 dB |
| Modulation Distortion | Less than 5 % |
| Microphone Impedance | 2kΩ |
| Measurement | TIA/EIA-603 |
KENWOOD follows a policy of countinuous advancement in development.
For this reason specifications may be changed without notice.
FleetSync® is a registered trademark of KENWOOD Corporation.
Windows® is a registered trademark of KENWOOD Corporation in the United State and other countries.
| Standard | MIL 810C Methods/Procedures |
MIL 810D Methods/Procedures |
MIL 810E Methods/Procedures |
MIL 810F Methods/Procedures |
|---|---|---|---|---|
| Low Pressure | 500.1/Procedure I | 500.2/Procedure I, II | 500.3/Procedure I, II | 500.4/Procedure I, II |
| High Temperature | 501.1/Procedure I, II | 501.2/Procedure I, II | 501.3/Procedure I, II | 501.4/Procedure I, II |
| Low Temperature | 502.1/Procedure I | 502.2/Procedure I, II | 502.3/Procedure I, II | 502.4/Procedure I, II |
| Temperature Shock | 503.1/Procedure I | 503.2/Procedure I | 503.3/Procedure I | 503.4/Procedure I, II |
| Solar Radiation | 505.1/Procedure I | 505.2/Procedure I | 505.3/Procedure I | 505.4/Procedure I |
| Rain | 506.1/Procedure I, II | 506.2/Procedure I, II | 506.3/Procedure I, II | 506.4/Procedure I, III |
| Humidity | 507.1/Procedure I, II | 507.2/Procedure II, III | 507.3/Procedure II, III | 507.4 |
| Salt Fog | 509.1/Procedure I | 509.2/Procedure I | 509.3/Procedure I | 509.4 |
| Dust | 510.1/Procedure I | 510.2/Procedure I | 510.3/Procedure I | 510.4/Procedure I, III |
| Vibration | 514.2/Procedure VIII, X | 514.3/Procedure I | 514.4/Procedure I | 514.5/Procedure I |
| Shock | 516.2/Procedure I, II, V | 516.3/Procedure I, IV | 516.4/Procedure I, IV | 516.5/Procedure I, IV |
| International Protection Standard | ||||
| Dust & Water Protection | IP54/55 | |||
*To meet IP54/55, the 2-pin connector cover has to be connected on the radio; the locking bracket has to attached to the KMC-45 external speaker microphone.
