| GENERAL | ||
|---|---|---|
| Frequency Range | 245.0000 - 245.9875 MHz | |
| Number of Channels / Zones | 250* / 2 | |
| Channel Spacing | 12.5 kHz | |
| Operating Voltage | 7.5 V DC ±20 % | |
| Battery Life (5-5-90 duty cycle, saver off / on) | with KNB-45L (2000 mAh) | Approx. 12 hours / Approx. 18 hours |
| with KNB-53N (1400 mAh) | Approx. 9 hours / Approx. 12 hours | |
| with KNB-29N (1500 mAh) | Approx. 10 hours / Approx. 14 hours | |
| Operating Temperature Range | -30°C ~ +60°C | |
| Frequency Stability | ±2.5 ppm (-30°C ~ +60°C) | |
| Antenna Impedance | 50 Ω | |
| Dimensions (W x H x D), Projections not Included | Radio only | 54 x 122 x 21 mm |
| with Battery | 54 x 122 x 33.7 mm | |
| Weight (net) | Radio only | Approx. 180 g |
| with KNB-45L | Approx. 300 g | |
| with KNB-53N | Approx. 365 g | |
| with KNB-29N | Approx. 380 g | |
| RECEIVER | ||
| Sensitivity (12 dB SINAD) | 0.28 μV | |
| Selectivity | 60 dB | |
| Intermodulation Distortion | 60 dB | |
| Spurious Response | 70 dB | |
| Audio Distortion | Less than 5 % | |
| Audio Output | 500 mW / 8 Ω | |
| TRANSMITTER | ||
| RF Output Power (High / Low) | 5 W / 1 W | |
| Spurious Response | 70 dB | |
| FM Hum & Noise | 40 dB | |
| Audio Distortion | Less than 5 % | |
| Modulation | 11K0F3E | |
*Available channel selection: 80 CB channels (245.0000 - 245.9875 MHz)
Measurements made per TIA/EIA 603 and specifications shown are typical. KENWOOD follows a policy of continuous advancement in development. For this reason specifications may be changed without notice.
FleetSync® is a registered trademark of KENWOOD Corporation.
| Standard | MIL 810C Methods/ Procedures |
MIL 810D Methods/ Procedures |
MIL 810E Methods/ Procedures |
MIL 810F Methods/ Procedures |
MIL 810G Methods/ Procedures |
|---|---|---|---|---|---|
| Low Pressure | 500.1/Procedure I | 500.2/Procedure I, II | 500.3/Procedure I, II | 500.4/Procedure I, II | 500.5/Procedure I, II |
| High Temperature | 501.1/Procedure I, II | 501.2/Procedure I, II | 501.3/Procedure I, II | 501.4/Procedure I, II | 501.5/Procedure I, II |
| Low Temperature | 502.1/Procedure I | 502.2/Procedure I, II | 502.3/Procedure I, II | 502.4/Procedure I, II | 502.5/Procedure I, II |
| Temperature Shock | 503.1/Procedure I | 503.2/Procedure I | 503.3/Procedure I | 503.4/Procedure I, II | 503.5/Procedure I |
| Solar Radiation | 505.1/Procedure I | 505.2/Procedure I | 505.3/Procedure I | 505.4/Procedure I | 505.5/Procedure I |
| Rain | 506.1/Procedure I, II | 506.2/Procedure I, II | 506.3/Procedure I, II | 506.4/Procedure I, III | 506.5/Procedure I, III |
| Humidity | 507.1/Procedure I, II | 507.2/Procedure II, III | 507.3/Procedure II, III | 507.4 | 507.5/Procedure II |
| Salt Fog | 509.1/Procedure I | 509.2/Procedure I | 509.3/Procedure I | 509.4 | 509.5 |
| Dust | 510.1/Procedure I | 510.2/Procedure I | 510.3/Procedure I | 510.4/Procedure I, III | 510.5/Procedure I |
| Vibration | 514.2/Procedure VIII, X | 514.3/Procedure I | 514.4/Procedure I | 514.5/Procedure I | 514.6/Procedure I |
| Shock | 516.2/Procedure I, II, V | 516.3/Procedure I, IV | 516.4/Procedure I, IV | 516.5/Procedure I, IV | 516.6/Procedure I, IV |
| International Protection Standard | |||||
| Dust & Water Protection | IP54 | ||||
| IP55 | |||||
