Amplifier Type | Class AB | ||
---|---|---|---|
CEA-2006 Primary Ratings | Power Output | 60Watts RMS x 4 at 4 Ohms and ≤1%THD+N | |
Signal-to-Noise Ratio | 80dBA (Reference: 1Watt into 4Ohms) | ||
Maximum Power Output | MAX POWER | 720W | |
Maximum Power Output | 180W x 4 | ||
Power Output | Rated Power at 14.4V | 60Watts RMS x [ch] (4 Ohms, 20-20kHz, ≤1.0% THD) 90Watts RMS x [ch] (2 Ohms, 1kHz, ≤1.0% THD) 180Watts RMS x [ch/2] (Bridged 4 Ohms, 1kHz, ≤1.0% THD) |
|
Specifications | Signal to Noise Ratio | 95dB (Reference: Rated Power into 4Ohms at 14.4V) | |
Total Harmonic Distortion | 0.08% (Rated Power at 4Ohms, 20-20kHz, 14.4V) | ||
Damping Factor | 500 (at 50Hz) | ||
Frequency Response | 5Hz-50kHz (+0dB, -3dB) | ||
Input Impedance | 10k ohm | ||
Audio Section | Low-Pass Filter (only B ch) |
Built in Variable Low-Pass Filter (50Hz-200Hz, -12dB/oct) | |
High-Pass Filter (only A ch) |
Built in High-Pass Filter (80Hz, -12dB/oct) | ||
RCA Input Sensitivity | 0.2 [V] - 5.0 [V] | ||
Speaker Level Input Sensitivity | 4.0 [V] - 12.0 [V] | ||
Terminals | Battery & Ground | Screw Type Terminal Block (Ni) (M6) | |
Speaker Output | Screw Type Terminal Block (Ni) (M4) | ||
Line In | RCA (Ni) | ||
Speaker Input | JST Connector | ||
General | Dimensions(WxHxD) | 330 [mm] x 55 [mm] x 215 [mm] 13 inch x 2-3/16 inch x 8-7/16 inch |
|
Operating Voltage |
14.4 [V](11-16V allowable) | ||
Key Features | CEA-2006 Compliant Speaker Level Input Power MOS-FET Switching Power Supply Cast Aluminum Heat Sink Design |