NX-200S | NX-300S | |
---|---|---|
GENERAL | ||
Frequency Range | 136 ~ 174 MHz | 400 ~ 470 MHz |
Number of Channels | 64 | |
Zones | 4 | |
Max. Channels per Zone | 16 | |
Channel spacing Analogue Digital |
12.5 / 20 / 25 kHz 6.25 / 12.5 kHz |
|
Operating Voltage | 7.5 V DC ± 20% | |
Battery life (with KNB-48L) 5-5-90 10-10-80 |
More than 14.5 hours More than 9.0 hours |
|
Operating Temperature Range | -30°C to +60°C | |
Frequency Stability | ±2.0 ppm | ±1.0 ppm |
Antenna impedance | 50 Ω | |
Dimensions (W x H x D), Projections not included Radio Only with KNB-47L with KNB-48L |
58 x 128.3 x 41.7 mm 58 x 128.3 x 41.7 mm 58 x 128.3 x 49.1 mm |
|
Weight (net) Radio Only with KNB-47L with KNB-48L |
255 g 370 g 400 g |
|
Applicable Standards ETSI R & TTE ETSI Safety |
EN 300 086, EN 300 113, EN 300 219, EN 301 489, EN 301 166 EN 60065, EN 60950-1, EN 60215 |
|
RECEIVER | ||
Sensitivity (Analogue) EIA 12dB SINAD (25kHz / 20kHz / 12.5kHz) EN 20dB SINAD | 0.28 µV / 0.28 µV / 0.32 µV -3 dB µV (0.35 µV) / -3 dB µV (0.35 µV) / -1 dB µV (0.45 µV) | |
Sensitivity (Digital) 3% BER (12.5kHz / 6.25kHz) 1% BER |
0.32 µV / 0.25 µV -1 dB µV (0.45 µV) / -4 dB µV (0.32 µV) |
|
Adjacent Channel Selectivity (Analogue) (25kHz / 20kHz / 12.5kHz) |
76 dB / 74 dB / 68 dB |
|
Intermodulation (Analogue) | 65 dB | |
Spurious Response Rejection (Analogue) | 75 dB | |
Audio Distortion | Less than 3% | |
Audio Output | 500 mW / 8 Ω | |
TRANSMITTER | ||
RF Power Output High / Low |
5 W / 1 W |
|
Modulation Limiting (Analogue) | ± 5.0 kHz at 25 kHz ± 4.0 kHz at 20 kHz ± 2.5 kHz at 12.5 kHz |
|
Spurious Emission | - 36 dBm <= 1 GHz, -30 dBm > 1 GHz | |
FM Noise (EIA) (Analogue, 25 kHz / 20 kHz / 12.5 kHz) |
45 dB / 45 dB / 40 dB |
|
Modulation Distortion | Less than 3% | |
Microphone Impedance | 1.8 kΩ | |
Modulation | 16K0F3E, 14K0F3E, 14K0F2D, 12K0F2D, 8K50F3E, 7K50F2D, 8K30F1E, 8K30F1D, 8K30F7W, 4K00F1E, 4K00F1D, 4K00F7W, 4K00F2D |
FleetSync® is a registered trademark of KENWOOD Corporation.
LTR® is a registered trademark of Transcrypt International.
AMBE+2TM is a trademark of Digital Voice Systems Inc.
Windows® is a registered trademark of Microsoft Corporation.
NXDN® is a registered trademark of KENWOOD Corporation and Icom Inc.
NEXEDGE® is a registered trademark of KENWOOD Corporation in Japan, Australia, Singapore and some other countries.
Analogue measurements made per EN Standards or TIA/EIA 603 and specifications shown are typical.
KENWOOD reserves the right to change specifications without prior notice or obligation.
MIL Standard | MIL 810C Methods/Procedures |
MIL 810D Methods/Procedures |
MIL 810E Methods/Procedures |
MIL 810F Methods/Procedures |
---|---|---|---|---|
Low Pressure | 500.1/Procedure I | 500.2/Procedure I, II | 500.3/Procedure I, II | 500.4/Procedure I, II |
High Temperature | 501.1/Procedure I, II | 501.2/Procedure I, II | 501.3/Procedure I, II | 501.4/Procedure I, II |
Low Temperature | 502.1/Procedure I | 502.2/Procedure I, II | 502.3/Procedure I, II | 502.4/Procedure I, II |
Temperature Shock | 503.1/Procedure I | 503.2/Procedure I | 503.3/Procedure I | 503.4/Procedure I, II |
Solar Radiation | 505.1/Procedure I | 505.2/Procedure I | 505.3/Procedure I | 505.4/Procedure I |
Rain | 506.1/Procedure I, II | 506.2/Procedure I, II | 506.3/Procedure I, II | 506.4/Procedure I, III |
Humidity | 507.1/Procedure I, II | 507.2/Procedure II, III | 507.3/Procedure II, III | 507.4 |
Salt Fog | 509.1/Procedure I | 509.2/Procedure I | 509.3/Procedure I | 509.4 |
Dust | 510.1/Procedure I | 510.2/Procedure I | 510.3/Procedure I | 510.4/Procedure I, III |
Vibration | 514.2/Procedure VIII, X | 514.3/Procedure I | 514.4/Procedure I | 514.5/Procedure I |
Shock | 516.2/Procedure I, II, V | 516.3/Procedure I, IV | 516.4/Procedure I, IV | 516.5/Procedure I, IV |
International Protection Standard | ||||
Dust & Water Protection | IP54/55 |