TK-D200G

GENERAL
Frequency Range  
136-174 MHz
Number of Channels
Display models
Non-display models
 
512 ch
64 ch
Zones per Radio
Display models
Non-display models
 
128 zones (max. 250ch/zone)
4 zones (max. 16ch/zone)
Channel Spacing
Analogue
Digital
 
12.5 / 20 / 25 kHz
12.5 kHz
Operating Voltage 7.5 V DC, ± 20%
Battery Life (5-5-90): Digital
KNB-55L (1,480 mAh)
KNB-56N (1,400 mAh)
KNB-57L (2,000 mAh)
 
Saver Off: More than 10 hours, Saver On: More than 14 hours
Saver Off: More than 8.5 hours, Saver On: More than 12 hours
Saver Off: More than 13.5 hours, Saver On: More than 19 hours
Operating Temperature Range*1 -30°C to +60°C
Frequency Stability ±1.5ppm
DimensionsAntenna Impedance 50 Ω
Dimensions(W x H x D)
Display models
 
 
Non-display models 
 
 
56.0 x 129.8 x 35.8 mm (with KNB-55L)
56.0 x 129.8 x 41.5 mm (with KNB-56N)
56.0 x 129.8 x 37.8 mm (with KNB-57L)
56.0 x 129.5 x 33.2 mm (with KNB-55L)
56.0 x 129.5 x 38.9 mm (with KNB-56N)
56.0 x 129.5 x 35.2 mm (with KNB-57L)
Weight (net)
Display models
 
 
Non-display models 
 
 
Approx. 353 g (with KNB-55L)
Approx. 452 g (with KNB-56N)
Approx. 380 g (with KNB-57L)
Approx. 343 g (with KNB-55L)
Approx. 442 g (with KNB-56N)
Approx. 370 g (with KNB-57L)
SAFETY ATANDARDS
R & TTE Safety Standard EN 300 086-2, EN 300 113-2, EN 300 219-2, EN 301 489-5, EN 300 440-2 (Receiver category 3) EN 60065, EN 60950-1, EN 60215, EN 62209 (SAR)
GPS
TTFF
Cold Start
Hot Start
 
<1 minute
<10 seconds
Horizontal Accuracy <10 meters
GPS Receiver Category Category 3
RECEIVER*2
Sensitivity
Digital @12.5 kHz
 
Analogue @25 kHz
Analogue @12.5 kHz
 
0.3 μV (5% BER), 0.45 dBμV emf (5% BER)
0.45 μV (1% BER), -1 dBμV emf (1% BER)
0.28 μV (EIA 12 dB SINAD), -3 dBμV emf (EN 20 dB SINAD)
0.32 μV (EIA 12 dB SINAD), -1 dBμV emf (EN 20 dB SINAD)
Adjacent CH Selectivity Analogue @25/12 kHz 76 dB / 68 dB
Intermodulation Analogue 65 dB
Spurious Response Rejection Analogue 75 dB
Audio Distortion Less than 3%
Audio Output 500 mW / 8 Ω
TRANSMITTER
RF Power Output 5 W / 1 W
Modulation Limiting
Analogue @25 kHz
Analogue @12.5 kHz
 
±5.0 kHz
±2.5 kHz
Spurious Emission -36 dBm ≤1 GHz, -30 dBm >1 GHz
FM Noise (BA) Analogue @25/12 kHz 45 dB / 40 dB
Modulation Distortion Less than 3 %
Vocoder Type AMBE+2™
Modulation 16k0F3E, 14K0F2D, 14K0F3E, 12K0F2D, 8K50F3E, 7K50F2D, 7K60FXD, 7K60FX3

*1: Operating temperature range of the KNB-55L/57L: -10°C to +60°C
*2: Analogue measurements made per EN 300 086 and 219; Digital measurements made per EN 300 113. Specifications are subject to change without notice, due to advancements in technology. Specifications shown are typical. AMBE+2™ is a trademark of Digital Voice Systems Inc. All other trademarks are the property of their respective holders.

Applicable Standards

Standard MIL 810C
Methods/
Procedures
MIL 810D
Methods/
Procedures
MIL 810E
Methods/
Procedures
MIL 810F
Methods/
Procedures
MIL 810G
Methods/
Procedures
Low Pressure 500.1/Procedure I 500.2/Procedure I, II 500.3/Procedure I, II 500.4/Procedure I, II 500.5/Procedure I, II
High Temperature 501.1/Procedure I, II 501.2/Procedure I, II 501.3/Procedure I, II 501.4/Procedure I, II 501.5/Procedure I, II
Low Temperature 502.1/Procedure I 502.2/Procedure I, II 502.3/Procedure I, II 502.4/Procedure I, II 502.5/Procedure I, II
Temperature Shock 503.1/Procedure I 503.2/Procedure I 503.3/Procedure I 503.4/Procedure I, II 503.5/Procedure I
Solar Radiation 505.1/Procedure I 505.2/Procedure I 505.3/Procedure I 505.4/Procedure I 505.5/Procedure I
Rain 506.1/Procedure I, II 506.2/Procedure I, II 506.3/Procedure I, II 506.4/Procedure I, III 506.5/Procedure I, III
Humidity 507.1/Procedure I, II 507.2/Procedure II, III 507.3/Procedure II, III 507.4 507.5/Procedure II
Salt Fog 509.1/Procedure I 509.2/Procedure I 509.3/Procedure I 509.4 509.5
Dust 510.1/Procedure I 510.2/Procedure I 510.3/Procedure I 510.4/Procedure I, III 510.5/Procedure I
Vibration 514.2/Procedure VIII, X 514.3/Procedure I 514.4/Procedure I 514.5/Procedure I 514.6/Procedure I
Shock 516.2/Procedure I, II, V 516.3/Procedure I, IV 516.4/Procedure I, IV 516.5/Procedure I, IV 516.6/Procedure I, IV
International Protection Standard
Dust & Water Protection IP54/IP55